Throttle Body Removal & Installation: Installation
- Clean mating surfaces and install new throttle body gasket (2) to intake collector (1).
- Install throttle body to intake collector and tighten bolts and nuts.
- Connect PCV hose to throttle body.
- Install throttle body and intake collector to intake manifold with new intake collector gaskets.
- Install EGR pipe with new gaskets.
- Connect breather hose. EVAP canister purge valve hose and PCV valve hose.
- Connect connectors of EVAP canister purge valve and EGR valve. Fix wire harness with clamps.
- Install clamp bracket to intake collector.
- Connect ground wire connector.
- Connect connectors of TP sensor and IAC valve.
- Install surge tank pipe and intake control valve to intake manifold with new gaskets and intake air pipe to throttle body. Install surge tank cover.
- Connect water hoses to throttle body.
- Connect accelerator cable.
- Install strut tower bar (1) and tighten strut tower bar mounting bolts (2) to specification.
Tightening torque
Strut tower bar mounting bolts (a): 50 N.m (5.0 kg-m, 36.5 lb-ft)
- Install fuse/relay box.
- Refill cooling system referring to COOLING SYSTEM FLUSH & REFILL .
- Connect negative (-) cable at battery.
- Adjust accelerator cable referring to ACCELERATOR CABLE ADJUSTMENT .