Intake Control Valve Inspection

Connect special tool (A) to intake control valve (1).
Special tool

(A): 09917-47011

Fig 1: Connecting Special Tool To Intake Control Valve
Courtesy of SUZUKI OF AMERICA CORP.
Apply vacuum to intake control valve (1) and verify that throttle (2) fully closes within the specified range. If intake control valve (1) fails the check, replace it.
CAUTION: Do not apply above 88 kPa of negative pressure. Damage may occur to intake control valve (1).

Valve operation pressure: 1.3 - 34 kPa (9.8 - 255 mmHg)
Let the throttle (2) close for 15 seconds with no vacuum application and inspect throttle travel. If throttle travel decreases, replace intake air valve (1).