Input Shaft Bearing Retainer and Oil Seal

Disassembly





Remove oil seal (1) from bearing retainer (2) by using flat end rod or the like as shown in figure.

NOTE: Unless oil seal is leaky or its lip is excessively hardened, replacement is not necessary.

Reassembly





Install new oil seal (2) to bearing retainer (1) by using special tool as shown in figure. Apply grease to oil seal lip.
"A": Grease 99000-25010
Special tool
(A): 09913-75821
(B): 09924-84510-004
Oil seal installing position "a": 12.2 - 13.2 mm (0.48 - 0.52 inch)