Seals and Gaskets: Service and Repair
Extension Case Oil SealRemoval and Installation
1. Lift vehicle horizontally.
2. Remove rear propeller shaft from extension case.
3. Pry shroud, felt and oil seal with flat-bladed tool.
4. Be sure to apply grease to oil seal lip. Using special tool and plastic hammer, press fit new oil seal (1), felt (2) and shroud (3) up to position ("a", "b") shown in the figure.
Extension case oil seal (2WD vehicle for A/T) installation position
"a": 1 mm (0.01 inch)
"b": 6.5 mm (0.25 inch)
"A": Grease 99000-25010
Special tool
(A): 09940-53111
5. Install rear propeller shaft.