LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2002 >> Vitara JLS, 4D Utility, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0496: EVAP System - High Purge Flow >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

NOTE: For better performance and results of this diagnostic procedure, usage of appropriate wiring diagram is recommended. See ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
NOTE: Perform all voltage and resistance tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use an ohmmeter to isolate wiring harness shorts or opens.
  1. If engine system check has been performed, go to next step. If engine system check has not been performed, perform A-4: ENGINE SYSTEM CHECK  under SYSTEM TESTS, then go to next step.
  2. Turn ignition switch to LOCK position. Check EVAP-CPV circuit. See EVAP CANISTER PURGE VALVE CIRCUIT under FUEL EVAPORATION under EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING article. If EVAP-CPV circuit is okay, go to next step. If EVAP-CPV circuit is faulty, go to step  4 .
  3. Perform FTP sensor component test. See FUEL TANK PRESSURE SENSOR under FUEL EVAPORATION under EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING article. If FTP sensor is faulty, replace FTP sensor and repeat DTC CONFIRMATION TEST  . If FTP sensor is okay, problem is intermittent. See INTERMITTENTS in TROUBLE SHOOTING - NO-CODES article. After repair, repeat DTC CONFIRMATION TEST  .
  4. Perform EVAP-CVV component test. See EVAP CANISTER VENT VALVE under FUEL EVAPORATION under EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING article. If EVAP-CVV is faulty, replace EVAP-CVV. After repair, repeat DTC CONFIRMATION TEST  . If EVAP-CVV is okay, check EVAP-CVV circuits for open or short in Blue/Black wire and Purple/Red wire between EVAP-CVV and ECM. If short or open circuit is found, repair as necessary. If short or open circuit is not found, substitute ECM with a known good unit and repeat DTC CONFIRMATION TEST  .