DTC Confirmation Test
- Ensure intake air temperature is 18°F (-8°C) or more, engine coolant temperature is 18-230°F (-8-110°C), vehicle is at an altitude of 8000 feet or below, and barometric pressure is 75 kPa or more.
- Turn ignition switch to LOCK position. Connect SUZUKI scan tool or equivalent to DLC, located below left side of instrument panel. See Figure . Turn ignition switch to ON position. Using scan tool, clear DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM.
- Start engine and allow it to reach normal operating temperature. Drive vehicle at more than 40 MPH for 5 minutes. Stop vehicle and let engine idle for 1 minute. Drive vehicle again until engine speed reaches 2000-3000 PRM, keep this engine speed for 30 seconds or more (engine speed should be kept constant). Stop vehicle.
- Repeat step 3 and stop vehicle. Using scan tool, check for current or pending DTC. See RETRIEVING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. If same DTC P0121 resets, see DIAGNOSIS & REPAIR PROCEDURE .