Control Module HVAC: Service and Repair

A/C Controller

Removal
1. Disconnect negative (-) cable at battery.
2. Disable air bag system, if equipped. Refer to "Disabling Air Bag System:".
3. Open glove box, then remove screw.
4. Remove glove box.
5. Disconnect A/C controller coupler (2), evaporator thermistor coupler (3).




6. Remove A/C controller (1) from heater unit (4).

Installation
1. Install in reverse order of removal procedure.
2. If equipped with air bag system, enable air bag system. Refer to "Enabling Air Bag System:".