Selector Shaft: Service and Repair

Manual Selector Assembly Components





Tightening torque
Manual selector assembly bolt (a): 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)

Manual Selector Assembly Removal and Installation
Removal for Type-1 [A]
1) Disconnect negative cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock solenoid and overdrive OFF switch.
4) Disconnect interlock cable from interlock cam of selector assembly.
5) Remove selector assembly mounting bolts.
6) Disconnect select cable from lever of selector assembly.

Installation for Type-1 [A]





NOTE:
^ Now selector assembly of Type-1 [A] is supplied with held interlock cam at interlock cable connecting position with pin (1). Remove this pin (1) after connecting interlock cable to interlock cam and tightening cable nut.
^ After installation, inspect select lever.

Reverse removal procedure to install noting the followings.
^ Connect interlock cable end to cam.
^ Upon completion of installation, confirm that brake (key) interlock system operates properly.

Removal for Type-2 [B]
1) Disconnect negative (-) cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock solenoid (if equipped) and overdrive OFF switch.
4) Remove selector assembly mounting bolts.





5) Disconnect selector cable (1) from manual selector assembly (2) expanding selector cable clip (3).

Installation for Type-2 [B]
Reverse removal procedure to install manual selector assembly noting the following instructions.
^ Make sure that selector cable clip (3) hold selector cable (1) on manual selector assembly (2) securely.
^ Connect interlock cable end to cam.
^ Upon completion of installation, confirm that brake (key) interlock system operates properly.
^ Tighten manual selector assembly mounting bolts as specified torque.
Tightening torque
Manual selector assembly mounting bolts: 18 Nm (1.8 kgf-m, 13.5 ft. lbs.)

Manual Selector Assembly Inspection





^ Check select lever for smooth and clear-cut movement and position indicator for correct indication. For operation of select lever, refer to the figure.
^ Confirm that brake (key) interlock system operates properly.