Diagnosis & Repair Procedure
- If engine system check has been performed, go to next step. If engine system check has not been performed, go to A4: ENGINE SYSTEM CHECK under SYSTEM TESTS.
- Visually inspect exhaust system for leaks, damage or loose connections. If problem is found, repair as necessary. After repair, repeat DTC CONFIRMATION TEST . If exhaust system is okay, go to next step.
- Start engine and allow it to reach normal operating temperature. Increase engine speed to 2000 RPM for one minute. Allow engine to return to idle. Rapidly increase engine speed 5-6 times repeatedly while monitoring HO2S No. 2 parameter on scan tool. If parameter varies from less than 0.25 volt to more than 0.35 volt, replace TWC. If parameter does not vary as specified, go to next step.
- Check for open or short in Blue wire between HO2S No. 2 and ECM harness connector C20 terminal No. 26. See Figure . See WIRING DIAGRAMS article. Also, check for open or short in Pink wire between HO2S No. 2 and ECM harness connector C99 terminal No. 11. If problem is found, repair as necessary. After repair, repeat DTC CONFIRMATION TEST . If no problem with wiring is found, replace HO2S No. 2. After repair, repeat DTC CONFIRMATION TEST . If DTC does not reset, testing is complete.