Power Door Lock Controller
NOTE:
Component test for power door lock and remote keyless entry controller was not available from manufacturer at time of publication.
- Disconnect power door lock controller harness connector. Power door lock controller is located behind driver's side kick panel. Using a fused jumper wire, connect battery voltage to power door lock controller terminal No. 6. See Fig 1 . Connect battery ground to terminals No. 1 and 5. Listen for relay operation inside controller (should make an audible click).
- Disconnect battery ground from terminal No. 5 and connect it to terminal No. 7. See Fig 1 . Relay inside controller should click. If controller does not function as described, replace power door lock controller.