Disabling & Activating Air Bag System
- For diagnostics, go to next step. For component removal and installation, place front wheels in straight-ahead position. Turn ignition switch to LOCK position and remove ignition key. Disconnect negative battery cable. Wait 90 seconds.
- For diagnostics, place front wheels in straight-ahead position. Turn ignition switch to LOCK position and remove ignition key. Remove AIR BAG fuse from AIR BAG fuse box. Junction block is located under left side of instrument panel. See Fig 1.
- Remove steering wheel side cap. Disengage Connector Position Assurance (CPA) clip and disconnect driver-side air bag module. See Fig 2.
- Pull top of glove box outward while depressing stops. Allow glove box to fall toward passenger seat. Disengage CPA clip and disconnect Yellow connector for passenger-side air bag module. See Fig 3.
- To activate air bag system, turn ignition switch to LOCK position and remove key. Reverse disabling procedure. Turn ignition switch to ON position and perform system operation check. See SYSTEM OPERATION CHECK .
Courtesy of SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.