LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2002 >> Esteem GL, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 1.6L >> Diagnostic Tests >> DTC P0112: Intake Air Temperature Sensor Circuit - Low Input >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

  1. If engine system check has been performed, go to next step. If engine system check has not been performed, go to A4: ENGINE SYSTEM CHECK  under SYSTEM TESTS.
  2. Turn ignition on. Using scan tool, observe IAT parameter. If parameter reads 246°F (119°C), go to next step. If parameter does not read 246°F (119°C), problem is probably intermittent. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES article.
  3. Turn ignition off. Disconnect IAT sensor 2-pin harness connector. IAT sensor is located in intake air pipe next to air cleaner housing. Turn ignition on. If parameter reading on scan tool changes to -40°F (-40°C), replace IAT sensor. After repair, repeat DTC CONFIRMATION TEST  . If parameter does not display as specified, go to next step.
  4. Check for short to ground in Gray/Red wire between IAT sensor and ECM 16-pin connector C20 terminals No. 14. See Figure . See WIRING DIAGRAMS article. If problem is found, repair as necessary. If no problem is found, substitute a known good ECM, and repeat DTC CONFIRMATION TEST  . If DTC does not reset, testing is complete.
scientia non olet · About LEMON Manuals