Power Mirror Motor
Remove garnish molding for access to power mirror electrical connector. See Fig 1 . It may be necessary to remove mirror from door for access to electrical connector. Disconnect power mirror harness electrical connector. Using 12-volt power source, connect positive and negative leads to specified terminals. See Fig 2 . See POWER MIRROR MOTOR TEST table. If power mirror motor does not operate as specified, replace power mirror assembly. See POWER MIRROR under REMOVAL & INSTALLATION.
POWER MIRROR MOTOR TEST
| Apply 12 Volts To Terminal No. | Ground Terminal No. | Mirror Operation | |||
|---|---|---|---|---|---|
| Esteem (1) | |||||
| 2 | 3 | Up | |||
| 3 | 2 | Down | |||
| 1 | 3 | Left | |||
| 3 | 1 | Right | |||
|
|||||