LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2002 >> Esteem GL, 4D Sedan, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 1.6L >> Diagnostic Tests >> DTC P1117: Engine Coolant Temperature Sensor No. 2 - Low Input >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

  1. If engine system check has been performed, go to next step. If engine system check has not been performed, go to A4: ENGINE SYSTEM CHECK  under SYSTEM TESTS.
  2. Turn ignition off. Disconnect ECT sensor No. 2 2-pin harness connector. ECT sensor is located in thermostat housing. See Figure . Disconnect ECM 16-pin harness connector C20. ECM is located under instrument panel, behind glove box. See Figure . Check continuity of Light Green wire between ECT sensor No. 1 and ECM. See Figure and WIRING DIAGRAMS article. If continuity exists, go to next step. If no continuity exists, go to step  4 .
  3. Repair short to ground in Light Green wire between ECM and ECT sensor No. 1. After repair, repeat DTC CONFIRMATION PROCEDURE  .
  4. Check ECT sensor No. 2 operation. See appropriate procedure under ENGINE SENSORS & SWITCHES in SYSTEM & COMPONENT TESTING article. If problem is found, replace ECT sensor No. 2. After repair, repeat DTC CONFIRMATION PROCEDURE  . If no problem is found, go to next step.
  5. Substitute a known good ECM, and repeat DTC CONFIRMATION PROCEDURE  . If DTC does not reset, testing is complete.
scientia non olet · About LEMON Manuals