Output Shaft Speed Sensor

Removal
1. Disconnect negative cable at battery.
2. Disconnect output shaft speed sensor coupler.





3. Remove output shaft speed sensor (1) by removing its bolt.

Installation
1. Apply A/T fluid to output shaft speed sensor O-ring.





2. Install output shaft speed sensor (1) to A/T case and tighten bolt to specified torque.
Tightening torque
Output shaft speed sensor bolt: 5.5 Nm (0.55 kgf-m, 4.0 ft. lbs.)
3. Connect output shaft speed sensor coupler to output shaft speed sensor.
4. Connect negative cable to battery.