Removal and Installation

Removal
1. Hoist vehicle and remove wheel.





2. Remove brake flexible hose mounting bolt (3) from caliper (1). As this will allow fluid to flow out of hose (2), have a container (5) ready beforehand.





3. Remove caliper pin bolts.
4. Remove caliper from carrier.

Installation
1. Install caliper to caliper carrier.





2. Torque caliper pin bolts (1) to specification.

NOTE: Make sure that boots are fit into groove securely.





3. Install brake flexible hose as shown and torque hose mounting bolt to specification.





4. Torque wheel nuts to specification.
5. After completing installation, fill reservoir with brake fluid and bleed brake system. Perform brake test and check each installed part for oil leakage.