Disassembly and Reassembly
Suspension Control Arm/Bushing Disassembly and AssemblyDisassembly
1. Cut rubber (1) of flange of suspension control arm front bushing.
2. Using grinder (3), grind off flange (2) of front bushing.
CAUTION: Be careful not to damage suspension control arm (4) when grinding flange (2) of front bushing with grinder.
3. Remove front bushing (1) using special tool (A) and hydraulic press (2).
Special tool
(A): 09913-75821
4. Remove rear bushing using special tools (B), (C) and hydraulic press (1).
Special tool
(B): 09945-55410
(C): 09924-84510-004
Reassembly
1. Press-fit front bushing (1) by using special tool (C) and press (2).
Special tool
(C): 09913-75810
CAUTION: Be sure to use new bushing.
NOTE: Before installing bushing, apply soap water on its circumference to facilitate installation.
2. Press-fit rear bushing by using special tools (B), (C) and hydraulic press (1).
Special tool
(B): 09945-55410
(C): 09924-84510-004
NOTE: Before installing bushing, apply soap water on its circumference to facilitate installation.