Fail Safe Data

This function is provided by the safe mechanism that assures safe driveability even when the solenoid valve, sensor or its circuit fails. The following table shows the fail safe function for each fail condition of sensor, solenoid, TCM or its circuit.

Fail Safe Data Table (1 Of 2)

DTC No.	Trouble area	Fail safe operation
P0753	21 22	Shift solenoid valve-A or its circuit	Power supply to shift solenoid valve, TCC solenoid valve and pressure control solenoid valve is cut. Gear position is fixed as shown in the following. When select lever position is R: Reverse D: 4th (O/D) 2: 3rd L: 1st Lock-up function is inhibited to operate. (Except P1702)
P0758	23 24	Shift solenoid valve-B or its circuit
P0748	41 42	Pressure control solenoid valve or its circuit
P1702	52	TCM
P0743	25 26	TCC solenoid valve or its circuit	Lock-up function is inhibited to operate. Up-shift to 4th gear is inhibited when A/T fluid temperature is 150 °C (302 °F) or higher. When TCC solenoid valve circuit open or shorted to power circuit, and vehicle speed is less than 10 km/h (6 mile/h), gear position is fixed in 1st gear for prevention of engine stall.
P0705 P0707	34	Transmission range sensor or its circuit	In case of circuit open, selected range is set as "D" range. In case of circuit short (In case that 2 or more sensor signals are inputted), selected range is set in priority order shown below. N > R > L > 2 > D > P
P0710	36 38	Transmission fluid temperature sensor or its circuit	Line pressure raising control at low fluid temperature is inhibited.
P0717	37	Input shaft speed sensor or its circuit	Power supply to shift solenoid valve and TCC solenoid valve is cut. Gear position is fixed as shown in the following. When select lever position is R: Reverse D: 4th (O/D) 2: 3rd L: 1st Lock-up function is inhibited to operate. Reverse control operation, which inhibit reverse driving at "R" range while vehicle runs forward more than 7 km/h (4 mile/h), is inhibited.
P0722	31	Output shaft speed sensor or its circuit

Fail Safe Data Table (2 Of 2)

DTC No.		Trouble area	Fail safe operation
P1700	32 33	Throttle position signal circuit	Power supply to shift solenoid valve and TCC solenoid valve is cut. Gear position is fixed as shown in the following. When select lever position is R: Reverse D: 4th (O/D) 2: 3rd L: 1st Lock-up function is inhibited to operate. Torque reducing requirement to ECM (torque reduction control) is inhibited.
P1705	51	Engine coolant temperature signal circuit	Engine coolant temperature is assumed as normal operating temperature, and controls of overdrive and lock-up is released from inhibition.
P1740	75	Cruise control signal circuit	O/D and lock-up off control by cruise control signal is inhibited.
P1895	27	Torque reduction signal circuit	Torque reducing requirement to ECM (torque reduction control) is inhibited.