Removal and Installation
GeneratorREMOVAL
1. Disconnect negative (-) cable at battery.
2. Disconnect generator lead ("B" terminal) wire and coupler from generator.
3. Disconnect canister with canister mounting bracket from body.
4. Remove generator belt. Refer to "COOLING FAN BELT" or "GENERATOR BELT".
5. Remove generator drive belt adjusting bolt and generator mounting bolts.
6. Remove generator.
INSTALLATION
1. Mount generator on the generator bracket.
2. Tighten generator bolts to specified torque.
Tightening torque
Generator mounting bolt and nut (a) : 23 N.m (2.3 kg-m, 16.5 lb-ft)
3. Install generator (cooling fan) belt. (G16 and H25, H27 engines) or "GENERATOR BELT" (J20 engine).
4. Install cooling fan belt (J20 engine only). Refer to "COOLING FAN BELT".
5. Connect "B" terminal (3) wire and coupler to generator.
Tightening torque
"B" terminal outer nut (b) : 8.0 N.m (0.8 kg-m, 6.0 lb-ft)
6. Install canister
7. Connect negative (-) cable at battery.