Table D - Air Bag Warning Lamp Cannot Indicate DTC By Flashing

Wiring Diagram:

CAUTION:
- Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according to flow table.
- When measurement of resistance or voltage is required in this table, use a tester along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to INTERMITTENT AND POOR CONNECTIONS.
- If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

TABLE TEST DESCRIPTION

STEP 1: Check "AIR BAG" monitor coupler.

STEP 2 : Check diagnosis switch circuit for air bag system.

Step 1 - 2:

Fig. For Step 2:

DIAGNOSTIC FLOW TABLE

NOTE: Upon completion of inspection and repair work, perform following items.
- Reconnect all air bag system components, ensure all components are properly mounted.
- Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.