Main Shaft

MAIN SHAFT ASSEMBLY





1. Remove circlip (1) from main shaft (2) as shown in the figure.





2. Pull out 5th gear (1), needle bush (2), needle bearing (3), main shaft bearing (4) and low gear (5) with puller (6) and press (7).





3. Remove synchronizer ring and ball (1).








4. Pull out low speed sleeve/hub assembly (1), needle bearing and 2nd gear (2) from main shaft.
5. Pull off synchronizer springs/keys and low speed sleeve from hub.








6. Remove circlip from front part of main shaft and pull out 3rd gear (1), needle bearing, synchronizer ring and high speed sleeve/hub assembly (2).