Transmission Rear Case

TRANSMISSION REAR CASE





1. Check that interlock cam component (1) moves smoothly in both turning direction and sliding direction.





2. Insert interlock cam component (1) to rear case (2).





3. Set interlock cam component (1) as shown in the figure and drive pin by using special tool.
Special tool (A): 09922-85811





4. Apply thread lock cement to thread of interlock cam plug (1) and tighten it to specification.
"A": Cement 99000-32020
Tightening torque
Interlock cam plug (a): 19 Nm (1.9 kg-m, 14.0 ft. lbs.)





5. Install oil seal to rear case so that end surface of oil seal becomes flush with that case. Apply grease to oil seal lip.
Grease: 99000-25010
Special tool (B): 09913-77510





6. Install counter shaft gutter (2) to transmission rear case (1).