Transmission Speed Sensor: Service and Repair

VSS (SPEEDOMETER) DRIVE GEAR AND SENSOR ROTOR (2WD VEHICLE)

REMOVAL





1. Remove extension case from transmission.
2. Remove circlip (7) and then pull off VSS (speedometer) drive gear (6).
3. Remove steel ball (3), spacer (5) and sensor rotor (4) from output shaft (1).

INSTALLATION
1. Make sure that key (2) is installed in the groove.
2. Install sensor rotor (4) and spacer (5) onto output shaft (1).
3. Install steel ball (3) and drive gear (6) onto output shaft (1).
4. Install new circlip (7) onto output shaft (1) and make sure that circlip (7) fits in groove.
5. Install extension case to transmission.