Shifter A/T: Service and Repair

MANUAL SELECTOR ASSEMBLY








Tightening torque (a): 18 Nm (1.8 kg-m, 13.5 ft. lbs.)








Tightening torque (a): 18 Nm (1.8 kg-m, 13.5 ft. lbs.)

REMOVAL
1. Disconnect negative cable at battery.
2. Remove console box.
3. Disconnect connector for illumination lamp, shift lock solenoid and overdrive OFF switch.
4. Disconnect interlock cable from interlock cam of selector assembly.
5. Remove selector assembly mounting bolts.
6. Disconnect select cable from lever of selector assembly.

INSTALLATION

NOTE: New selector assembly of type-1 is supplied with held interlock cam at interlock cable connecting position with pin (1). Remove this pin (1) after connecting interlock cable to interlock cam and tightening cable nut.








Reverse removal procedure to install noting the followings,
^ Connect interlock cable end to cam referring to steps 2 to 8 of "Interlock Cable Installation".
^ Upon completion of installation, confirm that brake (key) interlock system operates properly.

INSPECTION








Check select lever for smooth and clear-cut movement and position indicator for correct indication. For operation of select lever, refer to the figure.