Coast/Set, Resume/Accel and Cancel Switches

INSPECTION
1. Disable air bag system referring to "DISABLING AIR BAG SYSTEM".




2. Disconnect connector (1) of COAST/SET, RESUME/ACCEL and CANCEL switches.
3. Check for resistance between "SW" and "GND" terminals of disconnected switch connector (1) under each condition below.
If check result is not satisfactory, replace combination switch assembly.

COAST/SET, RESUME/ACCEL and CANCEL Switch specification
All switches released ("OFF") : Infinity
CANCEL switch pressed (ON) : About 0 Ohms
COAST/SET switch rotated (ON) : 200 - 240 Ohms
RESUME/ACCEL switch rotated (ON) : 820 - 1000 Ohms