DTC Confirmation Procedure
WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
- Engine coolant temperature at engine start: between-10 °C and 30 °C (14 °F and 86 °F).
- The following DTCs are not detected: P0101, P0102, P0103, P0112, P0113, P0116, P0117, P0118 and P0125
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch, clear DTC if any.
- Start engine and warm up to normal operating temperature.
- Drive vehicle more than 35 mph (60 km/h) for 10 min.
- Stop vehicle and run engine at idle speed for 1 min.
- Check DTC and pending DTC by using scan tool.