Contact Coil And Combination Switch Assembly Removal And Installation: Installation

Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at "LOCK" position.
Install contact coil and combination switch assembly to steering column.
NOTE: New contact coil and combination switch assembly is supplied with contact coil set and held at its center position with a lock pin (2) and seal (1). Remove this lock pin (2) after installing contact coil and combination switch assembly to steering column.

Fig 1: Removing Lock Pin
Courtesy of SUZUKI OF AMERICA CORP.
Connect all connectors that have been removed in REMOVAL .
Install steering column upper cover (2) and lower cover (3), and then tighten steering column cover screws (1).
CAUTION: When installing lower cover (3) and upper cover (2), be careful so that contact coil and combination switch lead wire is not caught between covers.

Fig 2: Installing Upper & Lower Steering Column Cover
Courtesy of SUZUKI OF AMERICA CORP.
Install steering column hole cover (1).

Fig 3: Installing Steering Column Hole Cover
Courtesy of SUZUKI OF AMERICA CORP.
Install steering wheel to steering column, refer to INSTALLATION .