Upper Case and Shifter

UPPER CASE AND SHIFTER





1. Remove back up light switch (2) and locating spring bolts (3) from upper case (1).
2. Take out locating springs and locating balls.





3. Remove 2 spring pins and pull out low speed gear shift shaft (3) and high speed gear shift shaft (2) in that order.
4. Pull out reverse gear shift shaft (1), then disconnect fork from shaft (1) by removing spring pin.
Special tool (A): 09922-85811

NOTE: Make sure that remaining gear shift shafts are all neutral position when removing a gear shift shaft.

5. Take out rubber plug and 2 interlock balls from case.
6. Remove interlock pin from high speed gear shift shaft.