Coolant Line/Hose: Service and Repair

COOLING WATER PIPES OR HOSES
REMOVAL
1. Drain cooling system.
2. To remove these pipes or hoses, loosen screw on each pipe or hose clip and pull hose end off.

INSTALLATION
Install removed parts in reverse order of removal procedure, noting the following:
^ Tighten each clamp bolt securely.





^ When installing water outlet pipe (1) to cylinder head, apply sealant to pipe bolt thread and then tighten it (J20 engine only).
"A": Sealant 99000-31110
^ Refill cooling system with proper coolant.
^ Check each part for leakage.