Brake Light Switch: Service and Repair
REMOVAL AND INSTALLATIONWARNING: Refrain from work while exhaust center pipe is hot.
NOTE: When replacing switch, use care not to let dust enter transmission through switch hole.
1. Lift up vehicle.
2. Remove coupler(s) (1) for switch wiring.
3. Replace back up light switch (1), connect and clamp as they were.
Tightening torque
Back up light switch (Type 1 ([A])) (a): 20 Nm (2.0 kg-m, 14.5 ft. lbs.)
Back up light switch (Type 2 ([B])) (a): 45 Nm (4.5 kg-m, 32.5 ft. lbs.)
4. Check switch for proper function with ignition switch turned ON and gear shifted to reverse position. Turn OFF switch after checking its function.