LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2001 >> Swift GA, Standard >> Repair and Diagnosis >> General Information >> Restraints >> Air Bag Deactivation Procedures >> MAZDA >> Disabling & Activating Air Bag System >> Disabling System (B Series Pickup)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disabling System (B Series Pickup)

NOTE: B Series Pickups are equipped with a passenger air bag ON/OFF switch. Turning switch off is not a substitute for completely disabling the passenger air bag.
  1. Obtain radio anti-theft protection code from vehicle owner prior to servicing vehicle or deactivate radio anti-theft function before disconnecting vehicle battery.
  2. Turn ignition switch to LOCK position and remove key. Disconnect and shield negative battery cable. Wait at least ONE MINUTE for back-up power supply to be depleted.
  3. Remove round plastic plugs on left and right side of steering wheel housing. Remove 2 bolts and lift off driver's air bag module. Unplug driver air bag module connector. Install Air Bag Simulator (418-F088) to clockspring side of driver air bag module electrical connector. See Figure.
  4. Open glove box. Press inward on sides of glove box, and lower glove box to floor. Remove passenger air duct. Remove 2 passenger air bag retaining bolts. Placing one hand in glove box opening, push passenger air bag module away from dash. DO NOT grab edges of passenger air bag deployment doors.
  5. Unplug passenger air bag module connector at rear of glove box opening. Install Air Bag Simulator (418-F088) to vehicle harness at passenger air bag assembly.
scientia non olet · About LEMON Manuals