LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2001 >> Swift GA, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brakes >> Component Tests >> Motor Test (Apply & Release) >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Turn ignition switch to LOCK position. Connect Tech 1 scan tool with ABS/Air Bag cartridge to DLC. Turn ignition on. Pump brake pedal several times to deplete vacuum reserve. Depress and hold brake pedal.
  2. Using scan tool, release one of the motors. Brake pedal should drop smoothly. As pedal drops, feedback current should momentarily drop to only a few amps (indicating motor movement) and then equalize to command current (6 amps). This indicates motor is no longer moving since piston has bottomed out.
  3. Rough or jumpy pedal movement indicates an intermittent motor connection. With brake pedal still depressed and at floor, apply the same motor. Brake pedal should smoothly rise back to top of its travel. Feedback current should momentarily drop to a few amps, then quickly increase to command current (10 amps). This indicates motor is no longer moving since piston reached top of bore ("home" position).
  4. If brake pedal does not move both up and down as indicated and no DTCs are present, monitor the feedback current closely while performing test again. If feedback current is only a few amps, motor is free spinning. Separate motor pack from hydraulic unit to diagnose problem. See MOTOR PACK FUNCTION TEST  .
scientia non olet · About LEMON Manuals