Starter Armature: Service and Repair
0.9 kW CONVENTIONAL TYPEARMATURE/YOKE
REMOVAL
NOTE: Before disassembling starting motor, be sure to put match marks at two locations (A & B) as shown in figure left so that any possible mistake can be avoided.
1. Remove magnetic switch.
2. Remove rear bracket.
3. Remove brush holder.
4. Remove armature and yoke.
INSTALLATION
Install in reverse order of REMOVAL, noting the following.
1. Apply grease. (Refer to STARTING MOTOR of GENERAL DESCRIPTION .)
NOTE: If ball of armature shaft came out when removed, be sure to apply grease to ball and put it back in.
2. Install armature into yoke.
3. Install yoke and armature into front housing while aligning match mark "B" provided before disassembly.
4. Install brush holder.
5. Install rear bracket.
6. Install magnetic switch.
7. Carry out PERFORMANCE TEST referring to INSPECTION .