Rear Speed Sensor Ring/Rotor

REMOVAL
1. Remove rear axle shaft assembly.








2. In order to remove sensor rotor (3) from retainer ring (2), grind with a grinder one part "A" of the sensor rotor (3) as shown till it becomes thin.

CAUTION:
^ Cover vinyl sheet (4) or the like over wheel bearing so that fine grains from grinding will not enter there.
^ Be careful not to go so far as to grind the retainer ring.





3. Break with a chisel (1) the thin ground sensor rotor (2), and it can be removed.

INSTALLATION





1. Press-fit sensor rotor (1) as shown in the figure.

NOTE: Use care not to cause any damage to outside of retainer ring.

2. Install rear axle shaft assembly.