LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2001 >> Grand Vitara JLS+, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P1500: Starter Signal Circuit Malfunction >> Diagnosis & Repair Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair Procedure

  1. Perform DTC CONFIRMATION TEST . If DTC P1500 is set, go to next step. If DTC P1500 is not set, problem is intermittent. System is okay at this time. See TROUBLE SHOOTING - NO CODES article.
  2. Backprobing, measure voltage between ground and PCM 28-pin connector C51-2 terminal No. 26 (Black/Yellow wire). See Figure. Start engine. If 0-1 volt exists, go to next step. If 0-1 volt does not exist, check for short to power in Black/Yellow wire between ignition switch and PCM 28-pin connector C51-2. See WIRING DIAGRAMS article. Repair as necessary and go to DTC CONFIRMATION TEST .
  3. Turn ignition off. Backprobing, measure voltage between ground and PCM 28-pin connector C51-2 terminal No. 26 (Black/Yellow wire). See Figure. Crank engine. If 6-14 volts do not exist, go to next step. If 6-14 volts exist, problem is intermittent. System is okay at this time. See TROUBLE SHOOTING - NO CODES article. If intermittent problem is not found, replace PCM and go to DTC CONFIRMATION TEST .
  4. Check for open in Black/Yellow wire between ignition switch and PCM 28-pin connector C51-2. See WIRING DIAGRAMS article. Repair as necessary and go to DTC CONFIRMATION TEST . If wire is okay, replace PCM and go to DTC CONFIRMATION TEST .
scientia non olet · About LEMON Manuals