Diagnosis & Repair Procedure
- Perform DTC CONFIRMATION TEST . If DTC P0122 is set, go to next step. If DTC P0122 is not set, problem is intermittent. System is okay at this time. See TROUBLE SHOOTING - NO CODES article.
- Turn ignition off. Disconnect TP sensor connector. Measure voltage between ground and TP sensor harness connector terminal No. 3 Gray/Red wire). Turn ignition on. If 4.5-5.5 volts exist, go to next step. If 4.5-5.5 volts do not exist, check for short to ground or open in Gray/Red wire between TP sensor and PCM 26-pin connector C51-3 terminals No. 11. See WIRING DIAGRAMS article. Repair as necessary and go to DTC CONFIRMATION TEST . If wire is okay, disconnect PCM 26-pin connector C51-3. Check for poor terminal contact at PCM 26-pin connector C51-3. If poor terminal contact is found, repair as necessary and go to DTC CONFIRMATION TEST . If terminal contact is okay, replace PCM and go to DTC CONFIRMATION TEST .
- Check TP sensor operation. See ENGINE SENSORS & SWITCHES in SYSTEM & COMPONENT TESTING article. Replace as necessary and go to DTC CONFIRMATION TEST . If TP sensor is okay, check for short or open in Red/Green wire between TP sensor and PCM 26-pin connector C51-3 terminals No. 12. If wire is okay, disconnect PCM 26-pin connector C51-3. Check for poor terminal contact at PCM 26-pin connector C51-3. If poor terminal contact is found, repair as necessary and go to DTC CONFIRMATION TEST . If terminal contact is okay, replace PCM and go to DTC CONFIRMATION TEST .