Abs Warning Light Relay
Turn ignition off and disconnect negative battery cable. Locate ABS warning light relay in engine compartment fuse/relay block and remove relay. Resistance between relay terminals No. 3 and 5 should be 78-96 ohms at 68°F (20°C). See Fig 1 . Continuity should exist between relay terminals No. 1 and 4. No continuity should exist between relay terminals No. 1 and 2. Using jumper wires, apply battery positive voltage to relay terminal No. 3 and battery negative voltage to relay terminal No. 5. Continuity should now exist between relay terminals No. 1 and 2. Replace ABS warning light relay if it does not test as specified.