Removal and Installation

REMOVAL
1. Hoist vehicle and remove wheel.





2. Remove brake flexible hose mounting bolt from caliper. As this will allow fluid to flow out of hose, have a container ready before hand.





3. Remove caliper pin bolts.
4. Remove caliper.

INSTALLATION





1. Install caliper to caliper carrier.
2. Torque caliper pin bolts to specifications.
Tightening Torque (a): 22 Nm (2.2 kg-m, 16.0 ft. lbs.)

NOTE: Make sure that boots are fit into groove securely.





3. Install brake flexible hose as shown and torque hose mounting bolt to specification.
Tightening Torque (b): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)





4. Torque wheel nuts to specification.
Tightening Torque (a): 85 Nm (8.5 kg-m, 61.5 ft. lbs.)
5. After completing installation, fill reservoir with brake fluid and bleed brake system. Perform brake test and check each installed part for oil leakage.