Removal & Installation
- Before proceeding, read air bag service precautions section. See AIR BAG SAFETY PRECAUTIONS . Disable the SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Sensing and Diagnostic Module (SDM) is located under center console. Disconnect negative battery cable. Remove front and rear center console box. Remove center garnish panel. Remove ashtray, clock, stereo, stereo pocket, and stereo hole cover. Disconnect Sensing and Diagnostic Module (SDM) connector. Remove 3 bolts. Remove Sensing and Diagnostic Module (SDM) from vehicle. See Fig 1.
- To install, reverse removal procedure. Tighten SDM bolts to specification. See TORQUE SPECIFICATIONS . Make sure arrow on SDM is pointing toward front of vehicle. Reactivate SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .
Courtesy of SUZUKI