Repair Instructions: Actuator

Connect special tool, air compressor, actuator (1) and hoses as shown in the figure.
NOTE: Loosen adjusting screw of special tool before connecting hoses to special tool.

Special tool

(A): 09918-18110

Fig 1: Connecting Special Tool To Actuator
Courtesy of SUZUKI OF AMERICA CORP.
With pressure from compressor applied to special tool, adjust pressure to specified level by turning adjusting screw of special tool and check actuator for operation. Also, check that there is no air leakage from actuator.
Specified pressure for actuator Inspection: 38.0 kPa (0.38 kg/cm² , 5.40 psi)

Actuator stroke: 3 mm (0.118 in.)

Fig 2: Checking Teeth Of Free Axle Hub
Courtesy of SUZUKI OF AMERICA CORP.