LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2000 >> Swift GL, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> NIPPONDENSO (DENSO) >> Shaft Seal >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Shaft Seal: Installation

  1. Inspect compressor shaft and front housing bore for damage and/or excessive wear. Ensure "O" ring and shaft seal seat are clean. Apply refrigerant oil to compressor side of front housing bore. Lubricate "O" ring and shaft seal with refrigerant oil. Using a 21-mm socket, install shaft seal with "O" ring side facing away from compressor. Install shaft seal snap ring. See Figure.
  2. Install felt into felt retainer. Using a 14-mm deep socket, install felt and felt retainer. Lubricate compressor shaft. Install front housing using care not damage shaft seal lip. See Figure.
  3. Alternately tighten front housing through-bolts to 19 ft. lbs. (26 N.m). Install clutch plate center bolt. Using an INCH-lb. torque wrench, ensure compressor breakaway torque is 43 INCH lbs. (4.9 N.m) or less. To complete installation, reverse removal procedure. Ensure air gap between clutch plate and pulley is correct. See CLUTCH COIL .
scientia non olet · About LEMON Manuals