Drive Belt: Service and Repair

WATER PUMP BELT REMOVAL
1. Disconnect negative cable at battery.
2. Remove air cleaner assembly with outlet hose.
3. Loosen drive belt adjusting bolt.
4. Remove fender apron extension on right side and loosen generator pivot bolts.
When servicing car equipped with A/C, remove compressor drive belt before removing water pump belt.
5. Slacken belt by displacing generator and then remove it.

INSTALLATION
1. Install belt to water pump pulley, crankshaft pulley and generator pulley.
When servicing car equipped with A/C, install compressor drive belt, too.
2. Adjust belt tension.
For Adjustment of compressor drive belt tension
3. Tighten water pump belt adjusting bolt and pivot bolts.
4. Install fender apron extension on right side.
5. Connect negative cable at battery.