Rear Wheel Speed Sensor

REMOVAL

NOTE: Rear wheel speed sensor is serviceable only as an assembly.





1. Disconnect negative cable at battery.
2. Hoist vehicle and remove wheel.
3. Disconnect sensor coupler.
4. Remove rear wheel speed sensor from brake back plate.

INSTALLATION





1. Before installation, check followings:
^ Check O-ring for damage and deterioration. Replace if necessary.
^ Check to make sure that sensor tooth is free from any metal particles.





2. Install rear wheel sensor to brake back plate.
3. Tighten sensor bolt to specified torque.
Tightening Torque:
(a): 10 Nm (1.0 kg.m, 7.5 ft. lbs.)
4. Connect sensor coupler securely.
5. Tighten wheel nuts to specified torque and lower hoist.