Flow Control Solenoid

REMOVAL
1. Disconnect negative cable at battery.
2. Disconnect solenoid harness coupler.





3. Remove solenoid(s).

NOTE: Be sure that the seal is still attached to the solenoid when it is removed. If not, check the solenoid bore in the ABS actuator.

INSTALLATION





1. Install solenoid to ABS actuator.

NOTE:
^ Lubricate seal on solenoid with clean brake fluid.
^ Verify that the solenoid lip seal is properly positioned before solenoid is installed into the ABS actuator.
^ Position solenoid so that its electrical connector will face the same direction prior to removal.
^ By hand, press down firmly on the solenoid until its flange seats onto the ABS actuator.

2. Tighten solenoid mounting bolts.
Tightening Torque
(b): 4.5 Nm (0.45 kg.m, 3.5 ft. lbs.)
3. Connect solenoid harness coupler.
4. Connect negative cable to battery.
5. Bleed brake system.