Land Rover
- Replacement compressor is shipped with 6.1 ounces of refrigerant oil. Drain, measure, and discard oil from old compressor. Rotate compressor shaft to assist in complete draining. Drain refrigerant oil from replacement compressor equal to amount drained from old compressor, plus 0.7 ounce. Install sealing caps to compressor inlet and outlet ports until refrigerant lines are installed.
- If a sudden refrigerant loss has occurred, such as a burst line, most of the refrigerant oil will be lost. Remove compressor and drain refrigerant oil. Rotate compressor shaft to assist in complete draining. Add 4.4 ounces of refrigerant oil to compressor and install sealing caps to compressor ports until refrigerant lines are installed. If any other major components are replaced, add refrigerant oil as specified. See COMPONENT REFRIGERANT OIL CAPACITIES (LAND ROVER - NIPPONDENSO) table.
COMPONENT REFRIGERANT OIL CAPACITIES (LAND ROVER - NIPPONDENSO)
| Component |
Ounces |
| Condenser |
1.4 |
| Evaporator |
2.7 |
| Receiver-Drier |
0.7 |
| Refrigerant Line |
0.7 |
| System Total |
| Discovery |
6.1 |
| Range Rover |
5.1 |
| Sudden Discharge |
| Discovery |
4.4 |
| Range Rover |
3.4 |