Scroll, 6-CYL., 7-CYL. Or 10-CYL.: Audi

Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove compressor from vehicle. Replacement compressor is shipped with refrigerant oil.
Drain, measure and discard oil from old compressor. Drain refrigerant oil from replacement compressor and add oil equal to amount drained from old compressor, but not less than 2.7 ounces. Remainder of oil specified can be added to replacement accumulator or evaporator if necessary.
After adding oil to compressor, rotate compressor shaft about 10 times to circulate oil in compressor to prevent compressor damage. If any other major components are replaced, add refrigerant oil as specified. See COMPONENT REFRIGERANT OIL CAPACITIES (AUDI - NIPPONDENSO) table.

COMPONENT REFRIGERANT OIL CAPACITIES (AUDI - NIPPONDENSO)

Component

Ounces

Compressor

⁽¹⁾ 2.7

Condenser

⁽²⁾ 0.3

Evaporator

⁽²⁾ 0.7

Receiver-Drier

⁽²⁾ 1.0

Refrigerant Lines

⁽²⁾ 0.3

System Total

⁽¹⁾ 6.9-10.1

⁽¹⁾	Drain shipping oil from replacement compressor. Add refrigerant oil to replacement compressor equal to amount drained from old compressor, but not less than 2.7 ounces.

⁽²⁾	Plus amount drained from old component.