LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2000 >> Swift GA, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Air Conditioning Compressor Servicing >> SANDEN 7-Cylinder >> Clutch Coil >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Clutch Coil: Installation

  1. To install, reverse removal procedure. Align lug on clutch coil with hole in front housing of compressor. Install snap ring with chamfered side facing out. Position pulley squarely over coil. Ensure compressor boss and inside area of pulley bearing are clean and free of foreign material. Using Pulley Installer (09951-15510), press pulley onto compressor boss. Install pulley snap ring.
  2. Install shim(s) and shaft key. Install clutch plate using a plastic hammer and a tube with an inside diameter more than 0.34" (8.5 mm) and an outside diameter less than 0.75" (19 mm). Using feeler gauge, ensure air gap between clutch plate and pulley is 0.014-0.025" (0.35-0.65 mm). If air gap is incorrect, add or remove shim(s) as necessary. Connect clutch coil lead to compressor housing. Hold clutch plate and tighten compressor shaft nut to 13 ft. lbs. (18 N.m).
scientia non olet · About LEMON Manuals