LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2000 >> Swift GA, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Front Suspension) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Wheel Stud To Wheel Bearing/Hub Assembly
G04842736Courtesy of SUZUKI OF AMERICA CORP.
  1. Install the wheel stud to the wheel bearing/hub assembly from the bearing side of the hub flange.
  2. Place flat washers over the wheel stud being installer.
  3. Install the wheel nut or a hex head nut to the wheel stud.
  4. Gradually tighten the nut in order to draw the stud into the hub flange until the head of the wheel stud is fully seated against the hub flange.
  5. Remove the nut and flat washers.
    Fig 2: Identifying Wheel Bearing/Hub Assembly To Steering Knuckle
    G04842737Courtesy of SUZUKI OF AMERICA CORP.
  6. Install the wheel bearing/hub assembly to the steering knuckle. Refer to Installation Procedure .
  7. Install the tire and wheel assembly. Refer to INSTALLATION PROCEDURE .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals