LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2000 >> Swift GA, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Engine Sensors & Switches >> Mass Airflow (MAF) Sensor >> Esteem 1.8L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Esteem 1.8L

  1. Remove PCM but leave electrical connectors connected. Disconnect MAF sensor connector. Turn ignition no. Connect voltmeter between ground and MAF sensor connector Red/Black wire terminal. Turn ignition on. If battery voltage is present, go to next step. If battery voltage is not present, check wiring for an open circuit or poor connection.
  2. Turn ignition off. Reconnect MAF sensor connector. Turn ignition on. Measure voltage between ground and PCM connector C20 terminal No. 24. See PIN VOLTAGE/CIRCUIT RESISTANCE CHARTS article for PCM connector and terminal identification. Voltage should be .5-1.0 volt. Start engine and ensure voltage is lower than 5 volts and increases as RPM increases. If voltages are to specification, system is okay. If voltages are not to specification, go to DTC P0101: MASS AIRFLOW (MAF) CIRCUIT PERFORMANCE PROBLEM under DIAGNOSTIC TESTS in SELF-DIAGNOSTICS - ESTEEM & SWIFT article.
scientia non olet · About LEMON Manuals