Vehicles Without A Wheel Hub

REMOVAL





1. Perform steps 1) to 5) off brake drum REMOVAL.
2. Perform steps 2) and 3) of brake shoe REMOVAL.
3. Perform steps 2) and 3) of wheel cylinder REMOVAL.
4. Remove cable from brake back plate by squeezing parking brake cable stopper ring.





5. Remove brake back plate.

INSTALLATION





1. Apply water tight sealant to mating surfaces of brake back plate and rear knuckle,
"A": Sealant 99000-31090





2. Install brake back plate and tighten back plate bolts to specified torque.
Tightening Torque (a): 23 Nm (2.3 kg.m, 17.0 ft. lbs.)





3. Install parking brake cable to brake back plate.
4. Install wheel cylinder, and tighten wheel cylinder bolts and brake pipe flare nut to specified torque. (Refer to steps 1) to 4) of wheel cylinder INSTALLATION.)
5. For procedure hereafter, refer to steps 5) to 12) of wheel cylinder INSTALLATION.